Liquid Roof

Liquid Roof
Liquid Roof

Saturday, February 23, 2008

EPDM Liquid Rubber Application

Application is best with a squeegee and a fine nap roller. Before applying, mix the pre-measured catalyst by following label directions. A single application is preferable to multiple coats. Touchups may be applied as desired after initial film has cured and surface is first wiped with solvent. To insure its effectiveness it must be applied at a 20 mil layer. Apply with brush around flashing and edges using long, slow strokes. On flat surfaces, material can be poured, spread with a squeegee and then evened out with a short nap roller. The Product will level itself when sufficient material has been applied. Liquid EPDM Rubber Roof should not be applied on cream color ALPHA rubber. For Further Information visit buyliquidroof.com.

No comments:

Post a Comment